"showgwports" command can be used to check status of Ethernet ETH connector ports on IB Switches (How To Doc)
Below is example output of showgwports command for reference.
In below output 0A-ETH-1 is enabled which means it is connected and link state is Down (likely due to port issue on upstream data center switch). 0A-ETH-3 is Disabled which means that it is not even connected to upstream switch. 0A-ETH-2 is the connector port which is enabled and link state is UP which means that it is operational.
Products to which Article Applies
Infiniband Switches
Below is example output of showgwports command for reference.
In below output 0A-ETH-1 is enabled which means it is connected and link state is Down (likely due to port issue on upstream data center switch). 0A-ETH-3 is Disabled which means that it is not even connected to upstream switch. 0A-ETH-2 is the connector port which is enabled and link state is UP which means that it is operational.
Port Bridge Adminstate Link State MTU TxPause RxPause
-------------------------------------------------------------------------
0A-ETH-1 Bridge-0-2 Enabled Down Reset 9600 Global Global
0A-ETH-2 Bridge-0-2 Enabled Up Up 9600 Global Global
0A-ETH-3 Bridge-0-1 Disabled Down Reset 9600 Global Global
0A-ETH-4 Bridge-0-1 Enabled Down Reset 9600 Global Global
Products to which Article Applies
Infiniband Switches
Article Author: Tarun Boyella
No comments:
Post a Comment