LINUX - ETHTOOL –I COMMAND TO SHOW DRIVER VERSION AND FIRMWARE VERSION BEING USED BY NETWORK BOND SLAVE INTERFACE

ETHTOOL –I COMMAND TO SHOW DRIVER VERSION AND FIRMWARE VERSION BEING USED BY SLAVE INTERFACE 

Following is the ethtool command to use to show driver and firmware version being used by network bond slave interface. 

# ethtool -i eth0

 

Below is sample output of above command. 

 

driver: mlx4_vnic 

version: 1.4.0 

firmware-version: 2.35.6308 [ORC1090120019] 

expansion-rom-version:  

bus-info: 0000:00:04.0 [mlx4_0:2] 

supports-statistics: yes 

supports-test: no 

supports-eeprom-access: no 

supports-register-dump: no 

supports-priv-flags: no 

[root@tarbots-ol7-1 ~]#  

▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬

Products to which Article Applies

All Linux OS’s

Article Author: Tarun Boyella